ANTI GRAFFITI PRODUCTS

ANTI-GRAFFITI PAINT

A unique one-pack external coating designed to give effective protection against both graffiti and fly-poster attack. Anti Graffiti Paint is a permanent not sacrificial system, allowing for repeated easy removal of any graffiti. Suitable for many surfaces, gives same day protection, repeat graffiti washes off with water.

Available in matt or gloss finish and has been specifically designed to minimise any alteration to the appearance of the protected surface.

This anti graffiti coating is suitable for a wide variety of surfaces. The matt version is particularly effective on the normally difficult to protect substrates such as rough brick or textured finishes.

The system can be used on concrete, render, masonry, porous stone, timber and previously painted surfaces, it should not however be used over Pliolite based products.

To test the suitability of Anti Graffiti Paint we recommend a small trial application be carried out.

Available in 5 or 20 litre tins.

Aplication

Stir contents thoroughly before application.

Apply by brush roller or spray. If spraying take care not to contaminate surrounding property. Thin with up to 10% white spirit if needed.

Apply a minimum of two coats at the suggested spread rate to achieve optimum results.

For further advice contact Homeorbis.

Properties

• Appearance Semi-transparent/Clear Liquid
• Solvent White Spirit
• Viscosity 2.5 to 3 Poise
• Solids 34 to 36 % by Weight
• Specific Gravity 0.85 to 0.88
• Shelf Life 12 months in unopened container
• UV Resistance Excellent

Other Data :

• Supplied in 5 and 20 litre containers
• Spread rate 10 m² per litre, less on a porous substrate.
• Drying time 1 to 2 hours, depending on conditions
• Re-Coat interval 4 hours
• Application Temp' Minimum 4 ºC
• Working Time Approx 30 to 90 mins.

Due to moisture curing nature of product do not leave in opened containers.Take care to clean equipment 
immediately after use.

BARE SURFACE GRAFFITI REMOVER

BSGR has been designed to remove graffiti from brick, concrete and stone, though it can be equally effective on other substrates.

As BSGR is an aggressive solvent based cleaner it is not suitable for use on previously painted surfaces or any that may be damaged by strong solvents.

If you are unsure we recommend that you do a small trial application to assess the products suitability.If you are in any doubt as to the suitability of the product contact with us.

Available in 5 litre tins

Aplication

Apply BSGR to the graffiti affected area using a brush. The product is gelled to assist application onto vertical surfaces.

Leave for 15 mins then test a small area to see if it has dissolved the graffiti, if not then leave for a further 15 mins.

Rinse off thoroughly with cold water, preferably using a pressure washer.